Vermont Castings 360DVSR Provozní pokyny stáhnout pdf (Strana 12)

Vermont Castings, Majestic Products, 360DVS Series

10002547

Your fireplace is approved to be vented either through

the side wall, or vertically through the roof.

• Only Vermont Castings, Majestic Products venting

components, specifically approved and labeled for

this fireplace, may be used.

• Venting terminals shall not be recessed into a wall

or siding.

• Horizontal venting must be installed on a level

plane without an inclining or declining slope.

There must not be any obstruction such

as bushes, garden shed, fencing, deck

or utility building within 24” (610 mm)

from the front of the termination hood.

Do not locate the termination hood

where excessive snow or ice buildup

may occur. Be sure to check the vent

termination area after snow falls; clear it

to prevent accidental blockage of the

venting system. When using a snow

blower, make sure snow is not directed

toward the vent termination area.

Location of Vent Termination

NOTE: It is imperative the vent termination be

located observing minimum clearances

as shown on the following page.

General Venting

Fig. 12 Honeywell Ignition Module.

This appliance may be fitted with a Honeywell ignition

module.

Installation of the remote ON/OFF starter switch on

electronic ignition units (Fig. 12):

1. Thread the wiring through the holes on the side

panels of the appliance. Take care not to cut the

wire or insulation on metal edges. Route the wire to

a conveniently located receptacle box.

2. Attach the wire to the ON/OFF switch and install

the switch into the receptacle box.

3. Connect the white wire from the wall switch to the

black wire from the transformer, using an approved

wire nut. Connect the black wire from the wall

switch to the black wire running from the #6

position of the ignition module, also using an

approved wire nut.

Electronic Gas Control Valve

PILOT

HONEYWELL IGNITION MODULE

BLUE

BLACK

WHITE

NOVA SIT 822 VALVE

POWER CORD

W/FEMALE SPADE

120 VAC RTN

WHITE

GREEN

BLACK

120 VAC HOT

BLACK

YELLOW

24 VAC RET

40VA TRANSFORMER

24 VAC HOT

BLACK

WHITE

WALL SWITCH

WHITE

OFF

1 2 3

4 5 6 8 9

MV MV/VP PV GRD 24V SENSE SPARK

24V

ORANGE

RED

GREEN

ORANGE

Honeywell_wiring

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Komentáře k této Příručce

Žádné komentáře

Vermont Castings 360DVSR Provozní pokyny Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Krby Vermont Castings 360DVSR